Anw: Initial creation

2012-09-28T15:02:16Z

Initial creation

New page

==Initial Setup==
Set up the printer with Bluetooth Authentication:
*Use Zebra Setup Utilities:
*Set Bluetooth Authentication
*Set the PIN to 0000 or 1234

Enable Bluetooth on the device:
*Manually turn on Bluetooth on the device
*From the Android Bluetooth settings screen:
**Detect devices
**Pair with the printer device
**Enter the PIN of the printer device.

==Usage==
Bluetooth must be enabled on the device to pick up the paired printers. If not, enable it - you do not have to exit the application, just switch to Android Settings/Bluetooth and enable it, then switch back.

If the printer is turned off, the application will warn that it cannot connect.

* Start the test application
* Click '''List Devices'''
* A table of previously-paired devices will be listed. The list will show the type of device. {{Note}} When the application is integrated, this list will show only paired printers. Currently the list shows all paired devices. Only the devices labelled as '''IMAGING''' are the printers.
* Click on the row of the device you wish to print to.
* A popup will show, ahowing options of:
** ''Test Connection''
** ''Print Label''
** ''Close''
* Choose ''Print Label'' and a popup will show of 3 options:
** ''Receipt (6 by 2)'' - this is the only label that will properly print on the MZ220. It will print on the QL420, although small.
** ''Despatch (6 by 4)'' - this is a fairly simple despatch label with a barcodes order and item.
** ''Parcel (6 by 4)'' - this is an example of a fairly complex DHL parcel label.
*Choose a label to print - a message should be shown of the status. In a couple of seconds, the label should appear on the printer.

Bluetooth Printing - Revision history

Anw: Initial creation