WMS/RDT Control Maintenance

Introduction

This document shows the configuration that is required on the WMS to enable the sending of tasks between the WMS and the Warehouse Control Server (WCS)

A familiarity is required of the use of the Calidus 3pl.

This document assumes that the RDT installation has taken place (as described in the document C3PL-M Installation Guide) and that set-up has occurred and a connection established to the Calidus 3pl.

System Parameters

In order to send RDT messages or tasks to Calidus 3pl-Mobile, the Calidus 3pl system must be informed that the Interface to Calidus 3pl-Mobile is present. This is enabled via the ‘RDT Interface’ flag on system parameters

image

Click on the Default Locations tab to identify the default locations required.

imnage

Build up location 3 (Q/A) is the default putaway location, if the putaway algorithm finds no locations. Location 6 is a Default Marshalling Location, used by pick list and allocation.